• Compatible with ISO 13503-2:2006
• For use with frac sand, resin coated sand and ceramic proppant

Carver Inc. is proud to introduce Model CMG28-12-PCR proppant Crush Test press. This Monarch Series press meets the critical demands of ISO 13503-2:2006 with unsurpassed cycle repeatability. The proportional hydraulic system is capable of applying a constant rate of 13.8 MPa/min. (2000 PSI min.) from 2 ton to 28 ton clamp force within a ±2.5% deviation. The operator interface allows easy setup of press control parameters and includes ample recipe storage.

• Compression force: 2-28 ton
• Minimum 1,275 psi on a 2" diameter crush die
• Maximum 17,800 psi on a 2" diameter crush die
• Hardened plates: 12” L-R x 12” F-B fully guided platens to ensure parallelism
• Positive stop on platens for centering the crush die
• Open daylight: 6”-12”
• Cylinder stroke: 6”
• Self-contained hydraulic system
• Available with and without 2” ID crush die (compatible with ISO 13503-2)
• “Mini” ViewPoint control system including:

• Allen Bradley programmable controller
• PanelView Touch screen interface
• Closed-loop control of clamp pressure
• Real time graphical display of process parameters
• Recipe storage (up to 30 recipes of 24 segments)
• Two hand close buttons
• Polycarbonate safety guards around the clamp area with manual sliding interlocked operator gate
• Dimensions: 46” w x 35” d x 74” h
• Weight: 1,900 lbs

• Compatible with ISO 13503-2:2006
• For use with frac sand, resin coated sand and ceramic proppant

Carver Inc. is proud to introduce Model CMG40-12-PCR proppant Crush Test press. This Monarch Series press meets the critical demands of ISO 13503-2:2006 with unsurpassed cycle repeatability. The proportional hydraulic system is capable of applying a constant rate of 13.8 MPa/min. (2000 PSI min.) from 2 ton to 40 ton clamp force within a ±2.5% deviation. The operator interface allows easy setup of press control parameters and includes ample recipe storage.

• Compression force: 2-40 ton
• Minimum 1,275 psi on a 2" diameter crush die
• Maximum 25,000 psi on a 2" diameter crush die
• Hardened plates: 12” L-R x 12” F-B fully guided platens to ensure parallelism
• Positive stop on platens for centering the crush die
• Open daylight: 6”-12”
• Cylinder stroke: 6”
• Self-contained hydraulic system
• Available with and without 2” ID crush die (compatible with ISO 13503-2)
• “Mini” ViewPoint control system including:

• Allen Bradley programmable controller
• PanelView Touch screen interface
• Closed-loop control of clamp pressure
• Real time graphical display of process parameters
• Recipe storage (up to 30 recipes of 24 segments)
• Two hand close buttons
• Polycarbonate safety guards around the clamp area with manual sliding interlocked operator gate
• Dimensions: 46” w x 35” d x 74” h
• Weight: 2,400 lbs